Salt spray test machine
-
It is mainly used for the surface treatment of various materials, including paint, electroplating, inorganic and surface coating, anode treatment, anti-rust oil and anti-corrosion treatment to test the corrosion resistance of its products. 、Using automatic/manual water filling system, it can automatically replenish the water level when the water level is insufficient, and the test will not be interrupted. The precision glass nozzle is uniformly dropped and diffused by the adjustable fog, the cone disperser of the spray tower of the fog amount, and naturally falls on the test card, and ensures that there is no blockage of crystal salt. The temperature controller uses a digital display, and the PID control is ±0.1℃. Double over-temperature protection, warning of insufficient water level to ensure safe use, the test is determined to use direct steam heating method, the heating rate is uniform, and the standby time is reduced. The saturated air barrel adopts Henry's law to heat and humidify, and provide the humidity required by the laboratory.
characteristic:
1. Spray method: continuous spray can be programmed spray.
2. It is made of one-piece PVC board, and adopts advanced ring-belt production three-dimensional reinforcement technology inside. The structure is strong and will never deform, and is resistant to acid and alkali, high temperature and never aging. It is suitable for various test specifications such as salt spray and copper acetate.
3. The control instruments are all on the same panel, which is easy to operate and clear at a glance.
4. Adopt double over-temperature protection, warning display when over-temperature, and cut off the heater power supply to ensure safe use.
5. The automatic/manual water filling system is adopted, which can automatically/manually replenish the water level when the water level is insufficient. The test is not interrupted and the water level is insufficient warning display.
6. The precision glass nozzle is made of special glass. It can be used for 4000 hours to ensure that there is no crystal blockage and the fog is uniform.
7. The imported thermometer adopts digital display PID automatic calculation to control the temperature, high stability platinum-plated temperature measuring probe, and the error is ±0.3℃.
8. Imported timer: digital display, accurate timing, can be set in H.
minutes, M. seconds, and any required test time. The available time range is from 0.01 second to 9999 hours/H.
9. The test chamber adopts steam direct heating method, which has a fast heating speed and shortens the standby time. The heating tube is made of high corrosion-resistant titanium tube.
10. The spray tower adopts a cone-shaped disperser, which has guided fog, uniformly drops the fog and adjusts the amount of fog.
11. Install a dehumidifying exhaust fan in the distribution box to prevent wet weather from damaging the control electrical appliances.
12. The mist seal groove adopts water sealing method and adopts automatic water filling method to prevent mist from leaking.
13. When the end is over, the indicator light will display, and the buzzer will sound.
14. The sealing cover of the large-scale machine test adopts the automatic lifting method of the pneumatic cylinder, which is convenient and safe to operate.
15. Equipped with an automatic defogging device, which can clean the samples in the observation laboratory.
16. The pressure tank adopts Henry's law to heat and humidify, and provide the humidity required by the laboratory.
